Documentation for connector and cable assignment of 1-Wire cable connections.
Dallas, the inventor of the 1-Wire technology, has a recommended assignment of CAT cables. This is used by ESERA, among others.
This Excel table contains both the Modbus addresses and the respective data labels for the ECO series.
Here you will find the programming manual for all 1-Wire Contoller, 1-Wire Gateway and ECO Controller.
The programming manual contains:
- the technical documentation sensors and actuators
- all commands for the 1-Wire controllers
- explanations of technical details of the 1-Wire controllers
- instructions for the interfaces, e.g. for the ECO208, ECO608 EIoT1000 etc.
Note, the programming manual can also be found within the ESERA Config Tool 3, under the DOCU tab.
Demonstration project for the Loxone Miniserver from the manufacturer Loxone. In this demo we would like to show you how you can connect a 1-Wire Controller / ECO Controller with a Miniserver from Loxone and exchange data.
Note: We created this demo a few years ago, but it should work comparably with the current version.
The software and your documentation is provided "as is" and without any warranty for function, correctness or freedom from errors.
Translated with www.DeepL.com/Translator (free version)
A USB driver is required for various products. Normally, a corresponding driver is loaded automatically under Windows. If this is not the case, you can find the appropriate driver for our USB interfaces here (external Link to FTDI): FTDI VCP Driver
The ECO-Dashboard 100 software is a fully automatic visualization for the ECO controllers and is based on the Auto-E-Connect system.
No settings have to be made for the visualization. The software exchanges all data on the connected sensors and actuators with the ECO Controller and displays the appropriate instruments. In addition, logging of sensor values is started in the background and graphs are written.
The ECO Dashboard 100 is a good example of how ESERA's Auto-E-Connect system works.
No knowledge about the ECO Controller is necessary. Just enter the IP address of the ECO Controller and off you go. This is how visualization is fun! :-)
The software is intended for:
The software is provided free of charge by ESERA. Based on this software, your visualization could also be implemented.
System requirements: Windows 7 or newer or Linux in Wine environment.
Warning: This is a Windows exe file, which can be reported as malicious by your antivirus program.
This application is checked, so you can ignore this message.
The ESERA-Station 200 is a hybrid system consisting of an ECO 200 controller and a quadcore Linux computer. The Station 200 is more like another central controller. It is an open platform, is a combination of an embedded computer and professional ESERA components.
It is an open automation control center built on standards. The ESERA-Station is usable for a wide range of software packages, Codesys*****, IP-Symcon, OpenHAB, FHEM, NodeRed and many more.
We provide the following software for download:
Here you will find the latest firmware for 1-Wire Controller 1, 1-Wire Controller 2 and the ESERA-Station 200 V1 (manufacturing year until 2020).
We provide two versions:
Note: Please download the firmware only if you are sure that it is the correct firmware for your device. If you are unsure, please contact us by mail via firstname.lastname@example.org